2000 Jeep Grand cherokee 4" RC lift

So after putting it on it took about 2 weeks to kill my front drive shaft even with the transfercase drop now im out a drive shaft and a replacement one is like 480    
2000 WJ 4.7, 4" RC lift magana flow and k&N cool air intake 88 Cherokee 4.5 RC lift 33s MT fount assuie locker

Ahhh, I bet you have one of the CV style front driveshafts with the rubber boot. The boot tears, the grease spits out, and the joint goes south. That type of front driveshaft only came in two model years ('99-'00) You can use junkyard parts if you can find them. The later models have U-joints at both ends of the front driveshaft. All you have to do is swap in the axle and transfer case yokes and the driveshaft itself from an '01-'02 WJ with a 4.7L. It's pretty easy.

Yours looks like this?
'99-'00 WJ Front Driveshaft  

Yes thanks  im just up set that they would not say anything about it. It really wasnt just the boot the flange around the boot instead of being round it has a big lump down i guess i hit a big bump and it bend the flange  
2000 WJ 4.7, 4" RC lift magana flow and k&N cool air intake 88 Cherokee 4.5 RC lift 33s MT fount assuie locker

I was also wondering if you know if i can replace my front upper control arm bushing cus all i can find online is the whole arm  
2000 WJ 4.7, 4" RC lift magana flow and k&N cool air intake 88 Cherokee 4.5 RC lift 33s MT fount assuie locker

Donno. Is it a stock upper arm? If so I think it will be worth just changing out the whole thing. Changing the bushings is a suck job.

If it's an RC upper arm call 'em. I'm sure they sell the bushings.